Morsa modulare MP 150X300

Modular clamps include 16 mm inserts (unless otherwise specified), a pipe wrench and a stop.

System clamps include 16 mm inserts (unless otherwise specified) and a pipe wrench.

Specify the dimensions of the table slots where CUTER clamps of the MODULARE or SYSTEM models will be installed.

Clamp made entirely of ground NiCrMo steel, hardness HRC 60÷62, tolerance 0.015.

FEATURES:

· Sliding block structure wider than the fixed jaw (excluding mod. 200÷250) with the possibility to clamp indifferently on hole grid plates or on T-slots;

· Mobile carriage with extremely long guides and gib to prevent lifting and lateral misalignment of the carriage;

· Screws and nut protected inside the carriage to prevent knocks or wear;

· Rapid approach system of the carriage to the workpiece without using a wrench;

Version with descending jaws