I-PAC 350 LAB

Single-phase inverter Plasma cutter for manual cutting on mild steel, aluminum and stainless steel.

i-PAC 350 is designed for small repair and construction jobs.
i-PAC 350 delivers 50 Amp and handles plates up to 12mm with a quality cut. If there are no special demands about the quality of the cut surface, the severance is up to 20mm.
The supply voltage is single phase at 230Volt. Can be connected to a motor generator (see technical data table).
The machine needs 130 liters of compressed air per minute.

The plasma arc is ignited automatically by the pilot arc. This means longer service life of wear parts in the torch body.
Cutting on perforated plates is possible due to the advanced technology that makes the machine switch between cutting arc and pilot arc.

Gouging Function: useful to remove lack of fusion in weld seam or to remove burrs from welded parts.

Equipment: DE50 torch 4m (010830) central connector, 3 nozzles (1 x Ø 0,9mm / 2 x Ø 0,8mm), Cable with ground clamp (3m), air connection (8/10mm).