I-PAC 340

Single-phase inverter plasma cutter designed for small repair and construction jobs. The I-PAC 340 enables manual cutting on ferrous and non-ferrous electrically conductive materials such as steel, copper, aluminium and stainless steel.

The unit delivers up to 35A and provides a quality cut on plates up to 8 mm. Where there are no special requirements for cut surface quality, severance is possible up to 12 mm. It runs on single-phase 230V supply and, thanks to its low energy consumption, can be used with reduced installed power; it can also be connected to a motor generator, according to the technical data table.

The plasma arc is automatically ignited by the pilot arc, helping extend the service life of wear parts in the torch body. Cutting on perforated plates is also possible thanks to the advanced technology that switches between cutting arc and pilot arc. The machine requires 115 litres of compressed air per minute.

Equipment:

• DE25 torch, 4 m
• 3 nozzles (Ø 0.8 mm)
• cable with ground clamp
• air connection (8/10 mm)