I-PAC 335K

Single-phase inverter plasma cutter with an integrated compressor.
Manual cutting can be done on any ferrous and non-ferrous materials as long as they are electrically conductive, such as copper steel, aluminum, stainless steel, and so on.

The i-PAC 335K is designed for small repair and construction tasks.

i-PAC 335K delivers 35 Amp and handles plates up to 8mm with a quality cut. If there are no special demands about the quality of the cut surface, the severance is up to 12mm.
The supply voltage is 230Volt single phase. Thanks to its low power consumption, it can be used with low installed power and can also be connected to a motor generator (see table for technical data).
The integrated compressor directly feeds the compressed air machine, eliminating the need for an air hose.

The plasma arc is ignited automatically by means of a pilot arc. This technology ensures longer life for the torch consumables.
Cutting on perforated plates is possible due to the advanced technology that makes the machine switch between cutting arc and pilot arc.

Equipment: DE25K torch 4m, 3 nozzles (Ø 0,8mm), Cable with ground clamp.