Morsa modulare MS 150X200

Modular precision vices are supplied with inserts (16 mm unless otherwise specified), a pipe wrench and a stop.

SYSTEM vices are supplied with inserts (16 mm unless otherwise specified) and a pipe wrench.

Specify the dimensions of the table slots where CUTER vices of MODULARE or SYSTEM models will be installed.

Vice fully made of ground NiCrMo steel, hardness HRC 60÷62, tolerance 0.015.

FEATURES:

· Sliding jaw structure wider than the jaw (excluding mod. 200÷250) with the possibility to clamp indifferently on hole grid plates or on T-slots;

· Moving carriage with extremely long guides and gib prevents lifting and lateral misalignment of the carriage;

· Screws and nut protected inside the carriage prevent knocks or wear;

· Rapid approach system of the carriage to the workpiece without using a wrench;

Version with jaw holder with fixed jaw SP and carriage with descending jaw MP