Morsa modulare MS 250X400

Modular vises are supplied with inserts (16 mm unless otherwise specified), pipe wrench and stop.

System vises are supplied with inserts (16 mm unless otherwise specified) and pipe wrench.

Specify the dimensions of the table slots where CUTER MODULARE or SYSTEM vises will be installed.

Vise fully made of ground NiCrMo steel, hardness HRC 60÷62 tolerance 0.015.

FEATURES:

· Sliding jaw structure wider than the jaw (excluding mod. 200÷250) with the possibility to clamp indifferently on hole-grid plates or on T-slots;

· Mobile carriage with extremely long guides and gib prevents lifting and lateral misalignment of the carriage;

· Screws and nut protected inside the carriage prevent impacts or wear;

· Rapid approach system of the carriage to the workpiece without using a wrench;

Version with jaw holder with fixed jaw SP and carriage with descending jaw MP